Mounting plate for the square basic inlet valve

 4,49

Description

After finishing the wall or floor, remove the cover plate and simply screw the vacuum contact into the pre-mounted screw holes in the flush-mounted box. The vacuum contact – inlet valves can be mounted either with the hinge at the top or at the bottom.

Now also connect the 24-volt signal cable. Use only the original flat screws provided. It is important that on non-level surfaces (e.g., clean masonry), the vacuum contact is not warped by screws that are too tight. Hand-tightening prevents unnecessary leakage of suction.

 

Additional information

Weight 0,02 kg

Extended due to success!

Switch to a central vacuum system this month and pick up a dust from this exclusive promotion.